Specifications

Installation and Upgrade Script Commands
To modify the default installation or upgrade script or to create your own script, use supported commands.
Use supported commands in the installation script, which you specify with a boot command when you boot
the installer.
To determine which disk to install or upgrade ESXi on, the installation script requires one of the following
commands: install, upgrade, or installorupgrade. The install command creates the default partitions,
including a VMFS datastore that occupies all available space after the other partitions are created. The
install command replaces the autopart command that was used for scripted ESXi 4.1 installations.
accepteula or vmaccepteula (required)
Accepts the ESXi license agreement. This command functions as it did in ESXi 4.1.
clearpart (optional)
Compared to kickstart, the behavior of the ESXi clearpart command is different. Carefully edit the
clearpart command in your existing scripts.
Clears any existing partitions on the disk. Requires install command to be specified.
--drives=
Remove partitions on the specified drives.
--alldrives
Ignores the --drives= requirement and allows clearing of partitions on every
drive.
--ignoredrives=
Removes partitions on all drives except those specified. Required unless the
--drives= or --alldrives flag is specified.
--overwritevmfs
Permits overwriting of VMFS partitions on the specified drives. By default,
overwriting VMFS partitions is not allowed.
--firstdisk=
disk-type1
[disk-type2,...]
Partitions the first eligible disk found. By default, the eligible disks are set to
the following order:
1 Locally attached storage (local)
2 Network storage (remote)
3 USB disks (usb)
You can change the order of the disks by using a comma separated list
appended to the argument. If you provide a filter list, the default settings are
overridden. You can combine filters to specify a particular disk, including
esx for the first disk with ESX installed on it, model and vendor information,
or the name of the vmkernel device driver. For example, to prefer a disk with
the model name ST3120814A and any disk that uses the mptsas driver rather
than a normal local disk, the argument is
--firstdisk=ST3120814A,mptsas,local.
dryrun (optional)
Parses and checks the installation script. Does not perform the installation.
Chapter 7 Upgrading and Migrating Your Hosts
VMware, Inc. 185