User`s guide

Appendix 10: Using the Adaptec Flash Utility for DOS ● 46
● HELP (next section)
● LIST on page 46
● SAVE on page 46
● UPDATE on page 47
● VERIFY on page 48
● VERSION on page 48
HELP
The
HELP command displays a summary of AFU functions and command switches.
Examples
The following are the examples of command syntax that will display the help:
A:\> AFU HELP
A:\> AFU /?
LIST
The
LIST command displays the AFU-supported SATA/SAS controllers installed on your
computer. Use this command to see which SATA/SAS controllers are installed, and to identify
the ID numbers assigned to each physical controller.
You do not have to restart the computer after completing this command.
Example
This example shows a typical system response to a
LIST command:
A:\> AFU LIST
Adaptec Flash Utility V1.0
(c)Adaptec Inc. 1999–2008. All Rights Reserved.
Controllers Detected and Recognized:
Controller #0 (03:01:00) ASC-1045/1405
SAVE
The
SAVE command saves the contents of a SATA/SAS controller’s flash in a UFI file. The name
of the UFI file is based on the SATA/SAS controller type and it cannot be modified.
Command Syntax
The command syntax for the
SAVE command is as follows:
AFU SAVE [/C< Controller ID >] [/D < UFI File Path >]
Command Switches
The following switches are available:
● /C <Controller ID> is the SATA/SAS controller(s) IDs representing the set of controller(s)
on which the command can be performed. By default, the AFU value set is Controller 0.