User`s guide

Chapter 7: Configuring the Controller Utility l36
2 Now select Ver i fy D i sk Media and press <Enter>.
3 A confirmation window appears. Click Ye s to verify the disk or No to cancel.
Locating a Disk
1 Select the disk you want to locate and press <Enter>.
2 Now select Indicate a LED and press <Enter>. The following options are displayed.
● Blink LED on all drives - Use this option to blink on all drives to ensure that the drives are
working properly.
● Blink LED on specific drive - Use this option to locate a specific drive.
Enabling/Disabling a Write Cache
1 Select the device/disk and press <Enter>.
2 Now select Write Cache Setting and press <Enter>.
● Select Enable to enable the Drive Write Cache and improve I/O performance.
● Select Disable to disable the Drive Write Cache and minimize I/O performance.
Viewing the PHY connection rate for the Disk
1 Select the device/disk and press <Enter>.
2 Now select Connection Rate and press <Enter>.
3 The PHY connection rate of the device/disk is displayed.
Setting a Bootable Device
1 Select the device you wish to mark as a bootable device and press <Enter>.
2 Now select Set Bootable and press <Enter>.
● Select Enable to boot from the device.
● Select Disable to disable the marked bootable device.
Note:
You can set only one device as a bootable device.