Operation Manual

prev. menu.
3. Keystone Correction Settings
Select “Keystone” icon on “SETUP”,then press “OK” button to enter keystone
correction settings.
Operating method: using “LEFT” or “RIGHT” button to choose desired parameter
values, then press “OK” button to confirm. “M” button will revert you back to the
prev. menu.
4. About: This displays the current software version
5. Default: This will restore to the system default settings
Battery Recharging
The projector is embedded with high capacity rechargeable Li-Polymer battery. When the
battery level indicator flashes as on the display, please charge it as soon as possible.
1. The Orange indicator will be on while charging and Green will be on while fully
charged. The Battery charging time is approximately 3 hours.
2. The projector can be operated while charging.
3. Connect the unit only to a power adaptor as described in this manual.Others are not
recommended by the manufacturer and may damage the unit. DC input must be 5V/2A.
4. The first time charge the battery for 8 hours and then use it till its totally empty. Repeat
this process a second time for the best battery performance. It is best to always use the
projector untill the battery is totally empty before recharging. Preferably do not charge
the projector when in use. This will improve the battery life.
Trouble Shooting
This part is to introduce some solutions to common problems, if any malfunction occurs,
please check the following first.If it still can not be solved, please contact the dealer or
authorized service center. Do not disassemble or repair it by yourself. If any questions you
can also visit the support section of www.adapt-mobile.com.
The following are some common problems and solutions for reference.
1. The Projector can not power on
● Battery has run out.Please recharge battery before operate.
● Failed to press “POWER” button.The power button is a sensitive component, don't
press it with too much force
2. Image blurring
● Focus is not well adjusted. Adjust the setting of the lens to a proper position.
● The light source of the projector is too close or too far from the projection screen.The
best distance is between 200MM-2000MM.
3. No sound
● The volume is set to "MUTE" or turned off.
N-11- N-12-