Installation Instructions

ManualsBrandsadapt ManualsCabinet Organization & Accessoriesadapt.™ 11" Stainless Steel Tip-Out Tray

P. 1

4814120/21 K-6956 K-6955 Sink tray installation instruction

Parts list

#2 #3

DESCRIPTION QTY

#1. Sink tray 1

#2. Hinges 1 left side, 1 right side

#3. Truss head screws 8

#4. Hinge template 1 left side, 1 right side

#5. Extension template 1 left side, 1 right side

#6. Sink tray screws 2

REQUIRED TOOLS

(not provided)

⊙ Drill

⊙ 3/32” Drillbit

⊙ Screwdriver

Summary of content (4 pages)

PAGE 1
Parts list #1 #2 #3 #4 #5 #6 DESCRIPTION #1. Sink tray #2. Hinges #3. Truss head screws #4. Hinge template #5. Extension template #6. Sink tray screws QTY 1 1 left side, 1 right side 8 1 left side, 1 right side 1 left side, 1 right side 2 P.
PAGE 2
Mounting instruction Step 1 Using a pencil, from the inside of your cabinet, trace around the frame perimeter of the sink front panel. Mark a “T” in the center to indicate the top of the panel. Note: A short pencil will provide for easier marking. Step 2 Remove the sink front panel. Take care not to damage it. Step 3 Place the provided hinge template (#4) on the face frame as shown and mark the (2) holes and pre-drill holes using a 3/32” drill bit. Repeat for the other side.
PAGE 3
Mounting instruction - continued Step 5 Lay the tray on the sink panel and position it 1/4 “ below and parallel with the top pencil line and centered side-to-side on sink panel. Hold tray in place and mark the slotted holes at top. Step 6 Once all the holes are marked, using a 3/32” drill, carefully drill all (6) marked hole locations. Be careful not to drill through the panel. Step 7 Attach the hinge “R” to the lower left corner of the sink front panel using (2) provided truss head screws.
PAGE 4
Mounting instruction - continued Step 9 Take the sink front panel and line it up with your cabinet opening and while extending the hinge, attach the hinge to face frame using (2) provided truss screws and a screwdriver. Repeat for the other end of sink panel. Step 10 Remove protective film from sink tray, install tray and tighten down screws. P.