Installation Instructions
Page 3 - Revision 03
Drill 1/16” pilot holes in the marked
locations.
Attach the Plastic Brackets to the
cabinet back wall using four Slide
Screws.
Insert the Slides into the Plastic
Brackets and attach the assembly
to the cabinet bottom using four
Slide Screws.
If the Lid Rack is to be bottom mounted, repeat Steps A1 to A6 for the Lid Rack.
NOTE: It is not typical to mount both racks to the cabinet bottom in the same
cabinet. Make sure there is enough room in the cabinet that the racks will not
interfere with each other, or any part of the cabinet, during operation.
STEP A7
STEP A4
STEP A5
STEP A6
NOTE:
If the Slides are not installed parallel, they may bind or be difcult to move during
operation.
Remove the Rack and check the operation of each Slide.
With the Rack removed, if the Slides do not bind when opening and closing, the
installation should be adjusted to make the Slides parallel, both horiztonally and
vertically.
Bottom Mount - STOP