Mounting chart Note: See instruction for side mount of bottom mount installation. Description 12” drawer Side mount Bottom mount 12” opening required Install on bottom of cabinet 12” or wider 15” drawer 15” opening required Install on bottom of cabinet 15” or wider 21” drawer 21” opening required Install on bottom of cabinet 21” or wider P.
Parts list #1 #2 #3 Use for bottom mount only #4 #5 #6 DESCRIPTION #1. Wood drawer #2. Cabinet glides #3. Template for bottom mounting #4. Mounting screws #5. Locking pins #6. Plastic mounting brackets QTY 1 1 left side, 1 right side 1 8 2 2 REQUIRED TOOLS (not provided) ⊙ ⊙ ⊙ ⊙ ⊙ Drill 1/16" Drillbit Screwdriver Tape measure Level P.
Bottom mounting instruction Step 1 Position template (#3) in center of cabinet. Make sure front of template is folded down along the front edge of cabinet. Step 2 Place plastic mounting brackets (#6) on sliders (#2) and place assembly in cabinet and align front mounting brackets of slider to the template cutouts and align outside edges of sliders to outside edges of template.
Bottom mounting instruction – continued. Step 5 Remove sliders and template from cabinet and drill 1/16” pilot holes in the marked locations. Step 6 Screw plastic mounting bracket to back wall using 4 screws (#4). Step 7 Reinstall the sliders in to the plastic mounting brackets and install 4 screws (#4) in the predrilled pilot holes of front mounting bracket. Step 8 Install wood drawer (#1) to sliders (#2) by aligning holes in the back of wood drawer with hooks in the top of the sliders.
Side mounting instruction Step 1 Hold the left slider (#2) against the insider of the cabinet face frame at desired height. Make a pencil mark at the top of the front bracket. Use a tape measure and record the height from the bottom of the cabinet to this mark. Note: Take in to consideration the sizes of items that will be stored and additional wire baskets that may be installed.
Side mounting instruction – continued. Step 4 Step 5 While holding the slider level and parallel to the inside wall, measure from inside wall to the center of front hole in the top of the slider. Record this dimension and mark it on the back wall on the line from step #2.
Side mounting instruction – continued. Step 6 Drill 1/16” pilot holes in the back wall and install plastic mounting bracket using (2) #4 screws. Step 7 Insert slider in the back plastic mounting bracket and reinstall screw (#4) in the front mounting bracket hole. Repeat steps on the right side of cabinet using same measurements as left side. Step 8 Install wood drawer (#1) to sliders (#2) by aligning holes in the back of wood drawer with hooks in the top of the sliders.