Specification Sheet

7160 Electric Strike
Specifications
FAIL-SAFE/FAIL-SECURE
• Field convertible from one mode to the other.
However, AC intermittent solenoid must not be used
continuously in either.
CASE
• Approximately 1" x 3-3/8" x 1-7/8" deep.
STRIKE LIP
• Basic 7160 strike has lip of proper length for 1-3/4"
thick door that closes flush with jamb edge. Where
door thickness or jamb shape differs from this standard
relationship, lip extension kits are available, specified by
last dash number.
STRIKE OPENING
• 3/4" x 1-7/16" x 5/8" deep. Bolt retainer jaw is stainless
steel. Strike location must be centered on latchbolt.
FACEPLATE
• Measures 1-1/4 x 4-7/8”. Faceplate is flat, with radiused
corners. Available in a wide range of architectural finishes.
VOLTAGE
• Available in 12 or 24 volt AC and DC. DC continuous units
are silent, AC intermittent units “buzz" on operation.
CURRENT DRAW/AMPS
VOLTS AC INTERMITTENT DC CONTINUOUS
12 1.42 0.33
24 0.74 0.17
STANDARD PACKAGE
• Individually boxed with mounting screws, mounting clips,
and adhesive shims to accommodate jamb extrusion
thickness greater or less than nominal 1/8".
OPTIONS
• Available with two monitoring signal switches which sense
whether latchbolt is in strike and whether strike jaw is blocked.
Choice of voltage in AC and DC for intermittent or continuous
duty. Specify assembled for either fail-secure (locked when
unpowered) or fail-safe (locked when powered) operation, but
can be field converted to the other mode.
7160 ELECTRIC STRIKE
7160 Electric Strikes with 4-7/8" faceplates are designed for
mortise or cylindrical type locksets with up to 3/4" latchbolt
projection without deadbolt. For use in aluminum jambs.
Function
Remote electrical control of any door equipped with a mortise or cylindrical
type lockset with up to 3/4" latchbolt projection without deadbolt. Electrical
actuation unlocks strike jaw, releasing latchbolt so door can be opened without
operating latch itself. Extremely compact mechanism fits into aluminum
jamb (or opposing door) sections as shallow as 1-7/8". Fits existing prep for
discontinued Adams Rite 7560, 7860 Electric Strikes.
ALUMINUM
UL 
BURGLARY
LISTED
ELECTRIFIED
PRODUCT
GRADE 1
E09321
All 3/4" throw latches
require 1/8" minimum
door gap. Horizontal center
line of strike must match line
of mortise latchbolt.
ELECTRIC STRIKES
ES-9
800.872.3267 • Fax [phone]
10027 S. 51st Street, Ste 102
Phoenix, Arizona 85044
www.adamsrite.com
ARM-014-9/14