Specification Sheet

7170 Electric Strike
Specifications
FAIL-SAFE/FAIL-SECURE
• Field convertible from one mode to the other.
However, AC intermittent solenoid must not be used
continuously in either.
CASE
• Approximately 1" x 3-3/8" x 1-7/8" deep.
STRIKE LIP
• Basic 7170 strike has lip of proper length for 1-3/4"
thick door that closes flush with jamb edge. Where
door thickness or jamb shape differs from this standard
relationship, lip extension kits are available, specified by
last dash number.
STRIKE OPENING
• 5/8" x 1-7/16" x 5/8" deep. Bolt retainer jaw is
stainless steel.
FACEPLATE
• Measures 1-1/4 x 4-7/8”. Faceplate is flat, with square
corners. Available in a wide range of architectural finishes.
VOLTAGE
• Available in 12 or 24 volt AC and DC. DC continuous units
are silent, AC intermittent units “buzz" on operation
CURRENT DRAW/AMPS
VOLTS AC INTERMITTENT DC CONTINUOUS
12 1.42 0.33
24 0.74 0.17
STANDARD PACKAGE
• Individually boxed with mounting screws. Includes
mounting clips and adhesive shims for use where welded
tabs are omitted.
OPTIONS
• Available with two monitoring signal switches which sense
whether latchbolt is in strike and whether strike jaw is blocked.
Choice of voltage in AC and DC for intermittent or continuous
duty. Specify assembled for either fail-secure (locked when
unpowered) or fail-safe (locked when powered) operation, but
can be field converted to the other mode.
7170 ELECTRIC STRIKE
7170 Electric Strikes with 4-7/8" faceplates are designed for
mortise or cylindrical type locksets with up to 3/4" latchbolt
projection without deadbolt. For use in hollow metal or
wood door jambs.
Function
Remote electrical control of any door equipped with a mortise or cylindrical
type lockset with up to 3/4" latchbolt projection without deadbolt. Electrical
actuation unlocks strike jaw, releasing latchbolt so door can be opened without
operating latch itself. Extremely compact mechanism fits into hollow metal
jamb sections as shallow as 1-7/8". Fits existing prep for discontinued Adams
Rite 7560AN, 7570, 7860AN, 7870 Electric Strikes.
The electric strike must be positioned to accommodate offset mortise latches
during installation. Please refer to installation instructions.
HOLLOW
METAL
WOOD
UL 
BURGLARY
LISTED
ELECTRIFIED
PRODUCT
GRADE 1
E09321
FITS STANDARD
MOUNTING
TAB ANSI PREP
3/32"
2.4
mm
All 3/4" throw latches
require 1/8" minimum
door gap. Horizontal center
line of strike must match line
of mortise latchbolt.
ELECTRIC STRIKES
ES-11
800.872.3267 • Fax [phone]
10027 S. 51st Street, Ste 102
Phoenix, Arizona 85044
www.adamsrite.com
ARM-014-9/14