User Guide

Placing Device on Body
Place the ADAMM-RSM™ wearable anywhere on the upper torso (the area below the base of
the neck and above the stomach on the front, side, or back).
Tip: Do not slouch when sticking on the ADAMM-RSM.
Tip: Figure out a few comfortable positions to wear the ADAMM-RSM and alternate
wearing it in those positions from day to day.
Charging
• Remove any adhesive from the back of the wearable.
• Place the wearable in the charging cradle with the gold points lined up as shown.
Close the cradle and secure it with the strap.
• Make sure the cradle is connected to the wall adapter and the wall adapter is plugged
into the electrical outlet.
NOTE: Only use the provided USB Adapter.
• The indicator light
7
will light on the wearable (it may take a few seconds). If the lights
do not show, power ON the wearable. Reset if required.
- Flashing RED - indicates the wearable is charging
- Steady RED - indicates the wearable is fully charged
• The device should NEVER be worn while charging.
Wi-Fi Syncing
• Press the wi-fi sync button
3
to enable Wi-Fi Sync feature on the ADAMM-RSM™ device.
During this time the indicator light
4
will flash BLUE in color.
NOTE:
Use Wi-Fi to upload data to cloud nightly or at least a few times a week.
How to Use ADAMM-RSM
Quick Start Guide
1 Pleasant St, Ste 442
Rochester, NY 14604 USA
Office: 585-471-8215
Email: [e-mail]
QSG-A0002