Specifications

@Adam Equipment Company 2006
5
3.4 SHIPPING PROTECTION
This ADK balance has protection for the weighing mechanism that must be
removed before the balance is used.
• To remove the shipping
protection, remove the pan
then place the balance on
the table upside down.
• Remove the cover over the
protection screw by
loosening 2 screws.
• Remove the protection
screw, place in a safe place
in case it is needed for
shipping the balance again.
Replace the cover.
3.5 VOLTAGE SELECTION
• This balance now includes a switch to select the mains voltage.
Verify the switch is set to the correct voltage for your area.
• The switch is located on the back panel under a small cover.
Remove the cover on the rear of the balance.
• Remove the cover by removing the small screws on the cover. Do
not remove the screws on either side of the cover.
• Select either 110V or 220V as required. The 110V position is for
power supplies from 110 - 120VAC and the 220V position is for
voltages of 220 – 240VAC.
RS-232 connector 110/220V Select Fuse
1/2A
On/Off
Weigh below
Attachment
Shipping Protection
ADK BALANCE