Specifications

@Adam Equipment Company 2006

3.3 SETTING UP THE BALANCE

• The ADK Series comes with a stainless steel platform packed

separately.

• Level the balance by adjusting the four feet. The balance should

be adjusted such that the bubble in the spirit level located on the

top of the base, is in the centre of the level.

• Place the platform in the locating holes on the top cover.

• Do not press with excessive force as this could damage the load

cell inside.

• Place the pan on top of the pan support.

• Plug in the cable into the main power supply and press the power

switch located at the rear of the base to ON to switch on the

balance. An arrow will appear in the display and will keep moving

across the icons marked below the display. Please note that the

display of the balance will not be on till the [On/Off] key is

pressed even though the balance is switched on.

• Press the [On/Off] key to switch on the display. A self-test is

followed. At the end of the self-test “0.0” will be displayed, if the

zero condition has been achieved. An arrow will appear above the

default unit which is g.

• The balance should be warmed up for at least one hour before

using.