Product Manual

15
©Adam Equipment 2017
To continue the USB device should be removed. The PMB will return to normal weighing
automatically. Or press the [Tare] key to escape back to normal weighing. To store or recall other files
plug the USB memory back into the analyzer
4.5 SERIAL INTERFACE
There is an RS-232 and USB interface that allows for both input and output of data to computers and
printers. For the USB serial interface a driver is required which can be found at
www.adamequipment.com.
Settings for the serial output can be configured under the supervisors menu. The RS-232 interface is
a simple 3 wire connection.
Connector: 9 pin D-sub miniature plug
Pin Type
Pin 2 Input to analyzer RXD
Pin 3 Output from analyzer TXD
Pin 5 Signal ground GND
Handshaking is not applied.
Baud rate: 2400, 4800, 9600, 19200, 38400
Parity: NONE (=8N1), EVEN (=8E1) or ODD (=8 O 1)
All lines are terminated with carriage return and line feed (<CR><LF>).
In continuous output mode, the serial output format will be a single line in the form “12.567
g<CR><LF>”.