Product Manual

5
©Adam Equipment 2017
SINGLE ºC
123
RAMP ºC RAMP TIME
123 06:00
STEP 1 TEMP ºC STEP 1 TIME
100 03:00
STEP 2 TEMP ºC STEP 2 TIME
120 03:00
STEP 3 TEMP ºC STEP 3 TIME
140 03:00
INTERVAL
SEC 10
Display shows rESULt
Options are: Moisture, Solid, ATRO
Moist, ATRO Solid
To set a test press the [Test] key
Use arrow keys, [Dspl] and [Test],
to change and press [Setup/Enter]
to continue.
Display, shows HEAt
Options are: Single, Ramp, Step
Use arrow keys, [Dspl] and [Test],
to change and press [Setup/Enter]
to select.
Option SINGLE
A single temp setting to heat to
Use arrow keys,
[Dspl] and [Test],
to change up and
down. The [Print]
and [PST] key to
move to the right
or left. Press
[Setup/Enter] to
continue.
Option RAMP
Will ramp up to a temperature with
a user defined time
Option STEP
Heats to one temperature for a set
time then to another temperature
for another period of time. There
are a maximum of 3 settings.
Display, shows INTERVAL
Set the time interval at which the
results are computed, displayed
and printed. Range is 1 to 99 sec.
Display, shows RAPID (not enabled
with RAMP heating)
Options: On, Off or manual (manual
asks each time the user runs a test)
Note: RAPID heat will cause the target temp to be 145% or
160°C (whichever is less) of the value set for single or the
first ramp step for a time of 3 minutes.
Rapid – off means the function is disabled, on means it will
always work for every test and manual will ask the user each
time the test is run.