Product Manual

14
©Adam Equipment 2017
4.4 STORE AND RECALL CONFIGURATION SETTING FROM USB MEMORY
To store or recall PMB settings on a USB memory, simply plug the memory into the USB hub
interface. The analyzer will detect the memory has been inserted and display a screen to guide you.
A message will be displayed showing the USB is installed.
To select the option of storing the configuration data to the memory press the [Dspl] key to change
the display to select Configuration Store
CONFIG ST
Press [Setup/Enter] to enter the configuration saving function. The display will show a suggested file
name. The name will be the next logical name for the configuration file based on what data is already
on the USB memory. For example if CONFIG1 and CONFIG2 are already stored, then it will display
CONFIG3.
Press [Setup/Enter] to confirm the action or, press [Tare] to escape back to the original USB display.
Once the file has been saved the display will show for 2 seconds then return to the main USB display.
To recall any stored configuration press the [Dspl] key to show the configuration load screen.
Press the [Setup/Enter] key to enter the test load function. The display will show the file name of the
first file found
.
To load this file press the [Setup/Enter] key again. Or to choose a different file press the [Dspl] key
to advance through the other available files.
CONFIG ST
USB
CONFIG3
USB
CONFIG3
Store
STORE OK
USB
CONFIG LD
USB
config1
USB
config1
LOAD