Product Manual

13
©Adam Equipment 2017
After loading the file the display will show a success message and return to the USB screen.
To continue, the USB device should be removed. The analyzer will return to normal weighing
automatically. Or press the [Tare] key to escape back to normal weighing.
To store or recall other test files plug the USB memory device back into the PMB.
4.3 STORING RESULTS IN USB MEMORY
A memory stick plugged into the USB host connector will allow for mass storage of test results. The
procedure is similar to the method used to store test settings
To store the results of a drying test on a USB memory, simply plug the memory into the USB hub
interface. The PMB will detect the memory has been inserted and display a screen to guide you.
A message will be displayed showing the USB memory is installed, then it will display the first
selection of actions that can be performed.
To select other options press the [Dspl] key to change the display to select Result Store, PST Store,
PST Load, Configuration store or Configuration load.
To store test results select
Press [Setup/Enter] to enter the test saving function. All of the test results stored in the internal
memory will be copied to the USB memory. The file names will be the same as those used to store
internally.
Once the file has been saved the display will show for 2 seconds, then return to the USB display.
RESULT ST
USB
RESULT ST
USB
STORE OK
USB
CONFIG Ld
USB