Product Manual

12
©Adam Equipment 2017
4.0 COMMUNICATION / INTERFACES
4.1 USING THE USB
The USB can be used to store results, test settings and configurations. For more detailed information
on the type of files and file structures please refer to the complete operators manual.
4.2 STORING AND RECALLING TEST SETTINGS FROM USB MEMORY
To store or recall test settings on a USB memory device, simply plug the device into the USB hub
interface. The PMB will detect the memory has been inserted and display a screen to guide you.
A message will be displayed showing the USB device is inserted, then the last setting:
To select the option of storing all of the test settings stored in the internal memory to the USB memory
device press the [Dspl] key to change the menu option to select Preset Store,
PST ST.
Press [Setup/Enter] to enter the test saving function.
Once the file has been saved the display will show for 2 seconds then return to the USB display.
To recall any stored test procedure press the [Dspl] key to show the test load screen.
Press the [Setup/Enter] key to enter the test load function. The display will show the file name of the
first test file found.
To load this file press the [Setup/Enter] key again. Or to choose a different file press the [Dspl] key
to advance through the other available files, then press the [Setup/Enter] key when the desired file is
shown.
CONFIG LD
USB
VERIFY
USB
PST ST
USB
SUCCESS
USB
PST ST
USB
PST LD
USB
PST 01
PSt