Product Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 TECHNICAL SPECIFICATIONS
- 3.0 UNPACKING THE SCALE
- 4.0 SETTING UP THE SCALE
- 5.0 KEYPAD AND DISPLAY
- Description
- Symbol
- 6.0 FUNCTIONS
- 6.1 bL = AUTOMATIC BACKLIGHT CONTROL
- 6.2 AVE = DISPLAY AVERAGING RATE
- 6.3 FIL = ADC FILTER RATE
- 6.4 bod = BAUD RATE SELECTION
- 6.5 cont = CONTINUOUS PRINTING
- 6.6 PIECE = PARTS COUNTING
- 6.7 StEPS = CHECK-WEIGHING FUNCTION (LOW-OK-HIGH)
- 6.8 CALIbr = CALIBRATION ROUTINE
- 6.9 rePL = RESULTS PRINTED AUTOMATICALLY OR MANUALLY
- 6.10 StAb = PRINT WHEN STABLE or INSTANTANEOUS
- 6.11 Aut = AUTOZERO FUNCTION
- 6.12 t1 = AUTOMATIC POWER SWITCH OFF
- 6.13 toP = HOLD MAXIMUM VALUE
- 6.14 nE = WEIGH IN NEWTONS
- 6.15 SuPP = Power supply voltage to PCB
- 7.0 COMMUNICATION WITH A COMPUTER/PRINTER
© Adam Equipment Company 2005
6
5.2 DISPLAY SYMBOLS
Symbol
Description
ZERO
Scale in auto zero range (indication = accurate zero)
STAB
Result is stable
PCS
Scale in parts counting mode
kg or g or t
Scale in weighing mode
BAT-LO
Batteries are weak, after 5 minutes the scale will turn off
TARE
Scale has been tared
When weight is above the High setpoint
When weight is between the setpoints
When weight is below the Low setpoint
- Lo -
During parts counting sample size is too small
6.0 FUNCTIONS
• To change functions press the [Func] key.
• The functions that are available can be cycled through by
pressing [Func] key.
• Not all functions may be enabled. Some functions may be set
during the initial configuration and the user is not given access to
them. In this case those will not be seen when the [Func] key is
pressed.
• To use any of the functions see the corresponding section of the
manual.
• If you continue to press the [Func] key you will eventually be
returned to weighing.
Functions Available
Function
Description
1.
bL
Enables / disables the backlight (if used)
2.
AVE
Changes averaging of weighing result
3.
bod
Changes baud rate for RS-232 transmission speed
4.
FIL
Changes ADC filtering
5.
cont
Enables or disables continuous printing
6.
PIECE*
Enters parts counting