Product Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 TECHNICAL SPECIFICATIONS
- 3.0 UNPACKING THE SCALE
- 4.0 SETTING UP THE SCALE
- 5.0 KEYPAD AND DISPLAY
- Description
- Symbol
- 6.0 FUNCTIONS
- 6.1 bL = AUTOMATIC BACKLIGHT CONTROL
- 6.2 AVE = DISPLAY AVERAGING RATE
- 6.3 FIL = ADC FILTER RATE
- 6.4 bod = BAUD RATE SELECTION
- 6.5 cont = CONTINUOUS PRINTING
- 6.6 PIECE = PARTS COUNTING
- 6.7 StEPS = CHECK-WEIGHING FUNCTION (LOW-OK-HIGH)
- 6.8 CALIbr = CALIBRATION ROUTINE
- 6.9 rePL = RESULTS PRINTED AUTOMATICALLY OR MANUALLY
- 6.10 StAb = PRINT WHEN STABLE or INSTANTANEOUS
- 6.11 Aut = AUTOZERO FUNCTION
- 6.12 t1 = AUTOMATIC POWER SWITCH OFF
- 6.13 toP = HOLD MAXIMUM VALUE
- 6.14 nE = WEIGH IN NEWTONS
- 6.15 SuPP = Power supply voltage to PCB
- 7.0 COMMUNICATION WITH A COMPUTER/PRINTER
© Adam Equipment Company 2005
7
7.
StEPS*
Enters check-weighing
8.
CALIbr
Calibration routine
9.
rEPL
Sets RS-232 to transmit automatically or manually
10.
StAB
Sets the RS-232 to print only when stable or at any time
11.
Aut
Enables/disables the autozero function
12.
t1
Enables/disables the automatic turn off
13.
toP
Enables/disables the maximum hold feature
14.
nE
Changes to measuring in Newtons
15.
SuPP
Displays the power supply voltage
• Most functions only require a simple enable or disable (0 or 1) or
a number that is incremented. Select the function using [Func],
then press [Print] to view the current setting. Pressing [Print]
again will change the setting to the next value. Pressing [Func]
again will return to normal weighing.
• On other functions (marked *) select the function by pressing
[Func]. Press [Print] to enter the function menu. The program
will then prompt you to enter values depending upon the function
selected. It is necessary to use [Tare] to select a digit to change
and press [Print] to increment the flashing digit. When all digits
have been entered press [Func] to go to the next step.
6.1 bL = AUTOMATIC BACKLIGHT CONTROL
• If the scale includes a backlight, it can be either enabled or
disabled.
• To set the parameter press the [Func] key to show “bL”
• Press [Print] to see the parameter.
• Press [Print] to select either “bL= 0” or “bL= 1”.
“bL= 0 “ Backlight is enabled.
“bL= 1” Backlight is disabled.
• Press the [Func] key to return to weighing.