Product Manual
Table Of Contents
- 1.0 INTRODUCTION
- 2.0 TECHNICAL SPECIFICATIONS
- 3.0 UNPACKING THE SCALE
- 4.0 SETTING UP THE SCALE
- 5.0 KEYPAD AND DISPLAY
- Description
- Symbol
- 6.0 FUNCTIONS
- 6.1 bL = AUTOMATIC BACKLIGHT CONTROL
- 6.2 AVE = DISPLAY AVERAGING RATE
- 6.3 FIL = ADC FILTER RATE
- 6.4 bod = BAUD RATE SELECTION
- 6.5 cont = CONTINUOUS PRINTING
- 6.6 PIECE = PARTS COUNTING
- 6.7 StEPS = CHECK-WEIGHING FUNCTION (LOW-OK-HIGH)
- 6.8 CALIbr = CALIBRATION ROUTINE
- 6.9 rePL = RESULTS PRINTED AUTOMATICALLY OR MANUALLY
- 6.10 StAb = PRINT WHEN STABLE or INSTANTANEOUS
- 6.11 Aut = AUTOZERO FUNCTION
- 6.12 t1 = AUTOMATIC POWER SWITCH OFF
- 6.13 toP = HOLD MAXIMUM VALUE
- 6.14 nE = WEIGH IN NEWTONS
- 6.15 SuPP = Power supply voltage to PCB
- 7.0 COMMUNICATION WITH A COMPUTER/PRINTER
© Adam Equipment Company 2005
11
6.7 StEPS = CHECK-WEIGHING FUNCTION (LOW-OK-HIGH)
• The check-weighing function will show a symbol on the left side of
the display to indicate if the current weight displayed is:
- above the High setpoint
- between the setpoints
- below the Low setpoint
• To enable the check-weighing function and set the value of the
setpoints press the [Func] key until “StEPS” is displayed.
• Press [Print] to enter the function. The display will then show all
zeros and the left most digit will be flashing. The LOW
symbol will be on.
• Use the [Tare] key to set the digit to be changed and the [Print]
key to set the value for the low setpoint. When the value is correct
press [Func] to go to the high setpoint.
• Set the high setpoint and press [Func] to return to weighing.
• The display will indicate when the weight shown is below the low
setpoint, between the setpoints or above the high setpoint.
• To disable the function press the [Func] key until either “PIECE” or
“StEPS” is displayed and then press the [Tare] key.