User Manual



• Press the [Tare/↵] key once the stability indicator comes on to confirm the

entered value. The display will show the number of pieces placed on the pan.

• If more items are put on the pan, the increased count value will be shown.

• Press [FUNC/↑] to exit and go back to the normal weighing mode.

5.3.2 PERCENTAGE WEIGHING

• In the weighing mode, press [FUNC/↑] until the display shows “PER”.

• Press the [Tare/↵] key to set the reference sample value, the display will

show “SET”.

• Place the item to be set at 100% on the pan and press the [Tare/↵] Key when

the stability indicator comes on.

• The display will show “.%”.

• When another item with a different weight value is put on the pan, the

relative % value would be shown against the initial reference sample value.

• Press the [FUNC/↑] key to exit and go back to weighing mode.

5.3.3 CHECK WEIGHING

• When in normal mode, press [FUNC/↑] until the display shows “CHECK”.

• Press [Tare/↵] to set the high limits. The display will show the “000000” with

one digit flashing and the ‘HI’ LED lit.

• Press [FUNC/↑] to increase the flashing digits;

• Press [UNITS/→] to select the digit;

• Press [Tare/↵] to accept the value and move to set the low limits. The display

will show “000000” with one digit flashing and the ‘LO’ LED lit.

• Use the same method the set the low limits and press [Tare/↵] to enter the

buzzer setting section,

• Press [FUNC/↑] to change the display to “BP INT” or “BP OUT” or “BP OFF”

to have beeper sound when the weight is outside the limits, between the

limits or off.

• Press [Tare/↵] to start the check weighing.

• Put the item on the pan, if the weight is below the low limits set, the scale

will show “xxxxx.x” with the ‘LO’ LED lit; if it is higher than the high limits set,