Datasheet

Wiring OLD 0.96" 128x64 OLED

128x64 Version 1.0 OLED

The version 1 128x64 OLED runs at 3.3V and does not have a built in level shifter so you'll need to use a level shifting

chip to use with a 5V microcontroller. The following will assume that is the case. If you're running a 3.3V

microcontroller system, you can skip the level shifter.

We'll assume you want to use this in a breadboard, take

a piece of 0.1" header 10 pins long.

Place the header in a breadboard and then place the

left hand side of the OLED on top.

This wiring diagram is only for the older 0.96" OLED that comes with a level shifter chip. If you did not get a

level shifter chip, you have a V2.0 so please check out the other wiring tutorial!