Datasheet

Assembly

The board comes with all surface-mount components

pre-soldered. Additional parts are included to help

integrate the INA219 breakout board into your project.

Wires can be soldered directly to the holes on the edge

of the board. But for breadboard use, you will want to

solder on the included 6-pin header.

The load can be connected via the header, or using the

included 2-pin screw-terminal.

Addressing the Boards

If more than one INA219 breakout board is used, each board must be assigned a unique address. This is done with the

address jumpers on the right edge of the board. The I2C base address for each board is 0x40. The binary address

that you program with the address jumpers is added to the base I2C address.