Datasheet

Assembly

Install the Servo Headers

Install 4 3x4 pin male headers into the marked positions

along the edge of the board.

Solder all pins

There are a lot of them!

Add Headers for Control

A strip of male header is included. Where you want to

install headers and on what side depends a little on use:

For breadboard (http://adafru.it/239) use, install

headers on the bottom of the board.

For use with jumper wires (http://adafru.it/758),

install the headers on top of the board.

For use with our 6-pin cable (http://adafru.it/206),

install the headers on top of the board.

If you are chaining multiple driver boards, you will want

headers on both ends.