Datasheet

display = Adafruit_IL0373(104, 212, spi, # 2.13" Tri-color display

cs_pin=ecs, dc_pin=dc, sramcs_pin=srcs,

rst_pin=rst, busy_pin=busy)

# IF YOU HAVE A FLEXIBLE DISPLAY (2.13" or 2.9") uncomment these lines!

#display.set_black_buffer(1, False)

#display.set_color_buffer(1, False)

display.rotation = 1

image = Image.open("blinka.png")

# Scale the image to the smaller screen dimension

image_ratio = image.width / image.height

screen_ratio = display.width / display.height

if screen_ratio < image_ratio:

scaled_width = image.width * display.height // image.height

scaled_height = display.height

else:

scaled_width = display.width

scaled_height = image.height * display.width // image.width

image = image.resize((scaled_width, scaled_height), Image.BICUBIC)

# Crop and center the image

x = scaled_width // 2 - display.width // 2

y = scaled_height // 2 - display.height // 2

image = image.crop((x, y, x + display.width, y + display.height))

# Display image.

display.image(image)

display.display()

So we start with our usual imports including a couple of Pillow modules and the ePaper display drivers.

import digitalio

import busio

import board

from PIL import Image, ImageDraw

from adafruit_epd.il0373 import Adafruit_IL0373

from adafruit_epd.il91874 import Adafruit_IL91874

from adafruit_epd.il0398 import Adafruit_IL0398

from adafruit_epd.ssd1608 import Adafruit_SSD1608

from adafruit_epd.ssd1675 import Adafruit_SSD1675

That is followed by initializing the PSI bus and defining a few pins here. The reason we chose these is because they

allow you to use the same code with the EPD bonnets if you chose to do so.

spi = busio.SPI(board.SCK, MOSI=board.MOSI, MISO=board.MISO)

ecs = digitalio.DigitalInOut(board.CE0)

dc = digitalio.DigitalInOut(board.D22)

srcs = None

rst = digitalio.DigitalInOut(board.D27)

busy = digitalio.DigitalInOut(board.D17)

We wanted to make these examples work on as many displays as possible with very few changes. The 2.13" Tri-color