User Manual

Connect Vin to the power supply, 3V or 5V is fine.

Use the same voltage that the microcontroller

logic is based off of

Connect GND to common power/data ground

Connect the SCK pin to Digital #13 but any pin can

be used later

Connect the SDO pin to Digital #12 but any pin

can be used later

Connect the SDI pin to Digital #11 but any pin can

be used later

Connect the CS pin Digital #10 but any pin can be

used later

Later on, once we get it working, we can adjust the library to use hardware SPI if you desire, or change the pins to

others.

Library Installation

You can install the Adafruit LPS35HW Library for Arduino using the Library Manager in the Arduino IDE. This will work