User Manual

Comment out option 1, and uncomment option 2 for the ST7789. Then you can change the TFT_ pins to whatever pins

you'd like!

The 2.0" IPS TFT display has an auto-reset circuit on it so you probably don't need to use the RST pin. You can change

#define TFT_RST 9

#define TFT_RST -1

so that pin isn't used either. Or connect it up for manual TFT resetting!

// OPTION 1 (recommended) is to use the HARDWARE SPI pins, which are unique

// to each board and not reassignable. For Arduino Uno: MOSI = pin 11 and

// SCLK = pin 13. This is the fastest mode of operation and is required if

// using the breakout board's microSD card.

#if defined(ADAFRUIT_PYBADGE_M4_EXPRESS) || defined(ADAFRUIT_PYGAMER_M4_EXPRESS)

// For PyBadge and PyGamer

Adafruit_ST7735 tft = Adafruit_ST7735(&SPI1, TFT_CS, TFT_DC, TFT_RST);

#else

// For 1.44" and 1.8" TFT with ST7735 (including HalloWing) use:

//Adafruit_ST7735 tft = Adafruit_ST7735(TFT_CS, TFT_DC, TFT_RST);

// For 1.3", 1.54", and 2.0" TFT with ST7789:

Adafruit_ST7789 tft = Adafruit_ST7789(TFT_CS, TFT_DC, TFT_RST);

#endif

// OPTION 2 lets you interface the display using ANY TWO or THREE PINS,

// tradeoff being that performance is not as fast as hardware SPI above.

#define TFT_MOSI 11 // Data out

#define TFT_SCLK 13 // Clock out

// For ST7735-based displays, we will use this call

//Adafruit_ST7735 tft = Adafruit_ST7735(TFT_CS, TFT_DC, TFT_MOSI, TFT_SCLK, TFT_RST);

// OR for the ST7789-based displays, we will use this call

//Adafruit_ST7789 tft = Adafruit_ST7789(TFT_CS, TFT_DC, TFT_MOSI, TFT_SCLK, TFT_RST);