Datasheet

A great low-cost add-on for Feather boards with the following features:
 Snap-in NeoPixel port - With a 3-pin JST connector, you can plug
in JST-wired NeoPixel strips directly, or use a 3-pin JST connector
to wire up your favorite shape of addressable NeoPixel LEDs. This
port provides high current drive from either the Feather Lipoly or
USB port, whichever is higher. A level shifter gives you a clean
voltage signal to reduce glitches no matter what chip you're using
 3W RGB LED drivers - 3 high current MOSFETs will let you connect
a 3W RGB LED for powerful eye-blasting glory. For most Feathers,
the 3 pins are PWM capable so you can generate any colour you
like. Available as pin breakouts plus strain-relief holes
 Triple-Axis Accelerometer with Tap Detection - You can use the
LIS3DH for motion detection, tilt or taps.
 Class D Audio Amplifier - Drive an 8Ω 1W speaker or 4Ω 3W
speaker for sound effects. Plug and play with an oval speaker,
or connect a picoblade cable for your favourite speaker. For use
only with Feathers that have analogue audio out such as the
Feather M0 Express and M4 series.
 Low power mode! The power system for the RGB LED, NeoPixels
and speaker amplifier can be controlled by a pin to cut power to
them, so you have lower power usage when the prop is in sleep or
off mode (but can wake up fast by listening to the button press or
accelerometer data). When the power pin is set low, the current
draw for just the wing is under 1mA and no there's current draw
from any attached NeoPixels - normally they're about 1mA even
when not lit.
 Breakouts plus strain-relief hole for the enable pin and ground
(for a mechanical switch that will power down the whole board)
 Breakouts plus strain-relief holes for an external switch pin and
ground (for a mechanical mode button)