Datasheet

Below the configuration values is the display class setup. There are 4 variants of OLED displays, with 128x32 pixels or

128x64 pixels, and with I2C or with SPI.

However since the PiOLED is a 128x32 I2C display

only

you should only use the

# 128x32 display with hardware I2C:

disp = Adafruit_SSD1306.SSD1306_128_32(rst=RST)

variant for creating the display object! The rest can remain commented out.

Note that above, we initialize RST = None because the PiOLED does not require a reset pin.

# Raspberry Pi pin configuration:

RST = None

# Note the following are only used with SPI:

DC = 23

SPI_PORT = 0

SPI_DEVICE = 0

# 128x32 display with hardware I2C:

disp = Adafruit_SSD1306.SSD1306_128_32(rst=RST)

# 128x64 display with hardware I2C:

# disp = Adafruit_SSD1306.SSD1306_128_64(rst=RST)

# Alternatively you can specify an explicit I2C bus number, for example

# with the 128x32 display you would use:

# disp = Adafruit_SSD1306.SSD1306_128_32(rst=RST, i2c_bus=2)

# 128x32 display with hardware SPI:

# disp = Adafruit_SSD1306.SSD1306_128_32(rst=RST, dc=DC, spi=SPI.SpiDev(SPI_PORT, SPI_DEVICE, max_speed_hz=8000000))

# 128x64 display with hardware SPI:

# disp = Adafruit_SSD1306.SSD1306_128_64(rst=RST, dc=DC, spi=SPI.SpiDev(SPI_PORT, SPI_DEVICE, max_speed_hz=8000000))

# Alternatively you can specify a software SPI implementation by providing

# digital GPIO pin numbers for all the required display pins. For example

# on a Raspberry Pi with the 128x32 display you might use:

# disp = Adafruit_SSD1306.SSD1306_128_32(rst=RST, dc=DC, sclk=18, din=25, cs=22)