Datasheet

Here are some of the updates you can look forward to when using Trinket M0:

Same size, form-factor, and pinout as classic Trinket

Updating ATtiny85 8-bit AVR for ATSAMD21E18 32-bit Cortex M0+

256KB Flash - 32x as much as 8 KB on ATtiny85

32 KB RAM - 64x as much as 512 bytes on ATtiny85

48 MHz 32 bit processor - 6x as fast as ATtiny85 (not even taking into account 32-bit speedups)

Native USB supported by every OS - can be used in Arduino or CircuitPython as USB serial console,

Keyboard/Mouse HID, even a little disk drive for storing Python scripts. (ATtiny85 does not have native USB)

Can be used with Arduino IDE or CircuitPython

Built in green ON LED

Built in red pin #13 LED

Built in RGB DotStar LED

All 5 GPIO pins are available and are not shared with USB - so you can use them for whatever you like!

Five GPIO pins with digital input/output with internally connected pullups or pulldowns

Three of the I/O pins can be used for 12-bit analog input

True analog output on one I/O pin - can be used to play 10-bit quality audio clips

We gave the M0 pads the exact same names as the original Trinket so all your existing Arduino code will

work exactly the same as-is without changes

Two high speed PWM outputs - for servos, LEDs, etc

Three pins can also be used as hardware capacitive touch sensors with no additional components required

Can drive NeoPixels or DotStars on any pins, with enough memory to drive 8000+ pixels. DMA-NeoPixel

support on one pin (https://adafru.it/xYD)so you can drive pixels without having to spend any processor

time on it.

Native hardware SPI, I2C and Serial available on two pads so you can connect to any I2C or Serial device

with true hardware support (no annoying bit-banging). You can have either one SPI device or both I2C and

Serial.

Same Reset switch for starting your project code over

Power with either USB or external output (such as a battery) - it'll automatically switch over