Datasheet

BLE UART: Controller

This examples shows you you can use the BLEUart helper class and the Bluefruit LE Connect applications to send

based keypad and sensor data to your nRF52.

Setup

In order to use this sketch, you will need to open Bluefruit LE Connect on your mobile device using our free

iOS (https://adafru.it/f4H), Android (https://adafru.it/f4G) or OS X (https://adafru.it/o9F) applications.

Load the Controller example sketch (https://adafru.it/vaN) in the Arduino IDE

Compile the sketch and flash it to your nRF52 based Feather

Once you are done uploading, open the Serial Monitor (Tools > Serial Monitor)

Open the Bluefruit LE Connect application on your mobile device

Connect to the appropriate target (probably 'Bluefruit52')

Once connected switch to the Controller application inside the app

Enable an appropriate control surface. The Color Picker control surface is shown below, for example (screen shot

taken from the iOS application):