Datasheet

Arduino Board Setup

Once you have the Bluefruit nRF52 BSP setup on your system, you need to select the appropriate board, which will

determine the compiler and expose some new menus options:

1. Select the Board Target

Go to the Tools menu

Select Tools > Board > Adafruit Bluefruit nRF52 Feather

2. Select the USB CDC Serial Port

Finally, you need to set the serial port used by Serial Monitor and the serial bootloader:

Go to Tools > Port and select the appropriate device

Download & Install CP2104 Driver (nRF52832)

For Feather nRF52832 If you don't see the SiLabs device listed, you may need to install the SiLabs CP2104

driver (https://adafru.it/vaH) on your system.

On MacOS If you see this dialog message while installing driver

And cannot find the serial port of CP2104, it is highly possible that driver is blocked.