User Manual

RGB NeoPixel that can be used for any purpose.

2 MB QSPI Flash storage chip is included on board. You can use the SPI Flash storage like a very tiny hard drive.

When used in Circuit Python, the 2 MB flash acts as storage for all your scripts, libraries and files. When used in

Arduino, you can read/write files to it, like a little datalogger or SD card, and then with our helper program, access

the files over USB.

Easy reprogramming, comes pre-loaded with the UF2 bootloader (https://adafru.it/wbC), which looks like a USB

storage key. Simply drag firmware on to program, no special tools or drivers needed! It can be used to load up

CircuitPython or Arduino IDE (it is bossa v1.8 compatible)

We have a working Arduino board support package, with lots of stuff working, but our primary target for this board is

CircuitPython - with 120 MHz, and 192KB or RAM CircuitPython runs really well on this chip!

We're starting off with a BETA marking on this board because this is the first development board with this chip so you

can expect 'excitement', 'adventure' and 'oops that doesnt work in this silicon revision'!

Here is our text when we first blogged about it (https://adafru.it/yaZ)