User Manual

https://adafru.it/CyD

https://adafru.it/CyE

Each Drive output is a PWM output, that means you can change the amount of current or speed of whatever is

connected.

Select which Drive pin you want to control with the pull down, Drive 1 through 4 are labeled on the Crickit

Then you can set the value from 0 (drive off) to 1023 (drive all the way on). If you want to dim an LED or run a vibration

motor at half power, use 512. For quarter power, use 256!

https://learn.adafruit.com/adafruit-crickit-creative-robotic-interactive-

construction-kit

Page 62 of 201