User Manual

Another common issue we see is not having good power to the Crickit. Check that you have fresh batteries or a good

5V power supply. Also check the Crickit is on! There's an on/off switch next to the power jack

Python: No Pullups found on SDL and SCL

This most often indicated the Crickit is not powered.

If you're running Crickit on battery power, you need fresh batteries.

If you use the wall power brick to provide power, ensure it is plugged in and the power switch is on.

If batteries aren't an issue, try clicking reset on the Crickit board to kick it back into running

micro:bit Crickit does not work

Be sure the micro:bit LED matrix faces towards the Crickit Seesaw chip and USB firmware update plug and the

micro:bit reset button faces the Crickit black power jack. If you plug the micro:bit in backwards, it won't control things

properly. Unplug the micro:bit, make sure the 5x5 grid of LEDs faces the Crickit printing that says "micro:bit LED grid

faces this way" and you should be set.

https://learn.adafruit.com/adafruit-crickit-creative-robotic-interactive-

construction-kit

Page 36 of 201