Datasheet

Sensor Terminal Blocks

If you have an RTD sensor, you need to connect it somehow! the terminal block area is where you can clamp down to

the sensor wires.

There are

four

contacts, but you can use 2, 3 or 4 wire sensors. You may need to solder or jumper some pads

depending on how many wires you want to use. You can also use a 3 or 4 wire sensor as a 3-wire or 2-wire sensor

(just don't connect the extra wires).

Check the RTD wiring page for details on how to connect the sensor you've got!

Configuration Jumpers