Datasheet

3-Wire Sensors

Connect the three wires to the three right-most contacts. Use a multimeter to determine which wires connect together

directly (2 ohms or so between them) and which connect through the RTD. Chances are the wires that connect

together are the same color. The two wires that are connected together should go in the right-most blocks (labeled F+

and RTD+). It doesn't matter which of the

matched

pair is on the outside or inside. The third wire that is on the other

side of the RTD connects to the left (marked F- or RTD-). It doesn't matter which slot it's in!