Datasheet

How To Wire Up!

4-Wire Sensors

Connect the four wires to each of the pads. Use a multimeter to determine which wires connect together directly (2

ohms or so between them) and which connect through the RTD. Chances are the wires that connect together are the

same color. The two pairs connect so that the ones that are connected together go into the two matching terminal

blocks on left or right. It doesn't matter which of the matched pair is on the outside or inside. It doesn't matter which of

the match pairs are on the left or right.

Do not solder closed any jumpers or cut any jumpers. Use as is!