Datasheet

AT+BLEHIDGAMEPAD

Sends a specific HID gamepad payload out over BLE

Codebase Revision: 0.7.0

Parameters: The following comma-separated parameters are available:

x: LEFT, RIGHT: If X=-1 then 'LEFT' is pressed, if X=1 then 'RIGHT' is pressed, if X=0 then neither left nor right are

pressed

y: UP, DOWN: If Y=-1 then 'UP' is pressed, if Y=1 then 'DOWN' is pressed, if Y=0 then neither up nor down are

pressed

buttons: 0x00-0xFF, which is a bit mask for 8 button 0-7

Output: Nothing

# Press 'RIGHT' and 'Button0' at the same time

AT+BLEHIDGAMEPAD=1,0,0x01

# Press 'UP' and 'Button1' + 'Button0' at the same time

AT+BLEHIDGAMEPAD=0,-1,0x03

AT+BLEMIDIEN

Enables or disables the BLE MIDI service.

Codebase Revision: 0.7.0

Parameters: State, which can be one of:

off

Output: If executed with no parameters, it will return the current state of the MIDI service as an integer indicating if it is

enabled (1) or disabled (0).

HID gamepad is disabled by default as of version 0.7.6, and must first be enabled via

AT+BLEHIDGAMEPADEN=1 before it can be used.



Note: You need to send both 'press' and 'release' events for each button, otherwise the system will think that

the button is still pressed until a release state is received.



Note: This command will require a reset to take effect.

