Datasheet

ManualsBrandsAdafruit ManualsAdafruitFeather 32u4 with Bluefruit LE and Stacking Headers, Assembled

111

112

113

114

115

116

117

118

119

120

0x9A Keyboard SysReq/Attention

0x9B Keyboard Cancel

0x9C Keyboard Clear

0x9D Keyboard Prior

0x9E Keyboard Return

0x9F Keyboard Separator

0xA0 Keyboard Out

0xA1 Keyboard Oper

0xA2 Keyboard Clear/Again

0xA3 Keyboard CrSel/Props

0xA4 Keyboard ExSel

0xE0 Keyboard LeftControl

0xE1 Keyboard LeftShift

0xE2 Keyboard LeftAlt

0xE3 Keyboard Left GUI

0xE4 Keyboard RightControl

0xE5 Keyboard RightShift

0xE6 Keyboard RightAlt

0xE7 Keyboard Right GUI

The following example shows how you can use this command:

# send 'abc' with left shift key (0x02) --> 'ABC'

AT+BLEKEYBOARDCODE=02-00-04-05-06-00-00

# Indicate that the keys were released (mandatory!)

AT+BLEKEYBOARDCODE=00-00

AT+BLEHIDEN

This command will enable GATT over HID (GoH) support, which allows you to emulate a keyboard, mouse or media

controll on supported iOS, Android, OSX and Windows 10 devices. By default HID support is disabled, so you need to

set BLEHIDEN to 1 and then perform a system reset before the HID devices will be enumerated and appear in on your

central device.

Codebase Revision: 0.6.6

Parameters: 1 or 0 (1 = enable, 0 = disable)

Output: None

You normally need to 'bond' the Bluefruit LE peripheral to use the HID commands, and the exact bonding

process will change from one operating system to another.



If you have previously bonded to a device and need to clear the bond, you can run the AT+FACTORYRESET

command which will erase all stored bond data on the Bluefruit LE module.

