Datasheet

AT+BLEUARTFIFO

1024,1024

AT+BLEUARTFIFO=TX

1024

AT+BLEUARTFIFO=RX

1024

AT+BLEKEYBOARDEN

This command will enable GATT over HID (GoH) keyboard support, which allows you to emulate a keyboard on

supported iOS and Android devices. By default HID keyboard support is disabled, so you need to set

BLEKEYBOARDEN to 1 and then perform a system reset before the keyboard will be enumerated and appear in the

Bluetooth preferences on your phone, where if can be bonded as a BLE keyboard.

Codebase Revision: 0.5.0

Parameters: 1 or 0 (1 = enable, 0 = disable)

Output: None

# Enable BLE keyboard support then reset

AT+BLEKEYBOARDEN=1

ATZ

# Disable BLE keyboard support then reset

AT+BLEKEYBOARDEN=0

ATZ

AT+BLEKEYBOARD

Sends text data over the BLE keyboard interface (if it has previously been enabled via AT+BLEKEYBOARDEN).

As of firmware version 0.6.6 this command is now an alias for AT+BLEHIDEN



You must perform a system reset (ATZ) before the changes take effect!



Before you can use your HID over GATT keyboard, you will need to bond your mobile device with the

Bluefruit LE module in the Bluetooth preferences panel.

