Datasheet

Bonnets and pHATs without worrying about an EEPROM address
collision.
You can customize your Perma-Proto setup using a standard 2x20
stacking header or extra tall 2x20 stacking header. You can also swap
out the 2x20 header with a slim 2x20 type if you want it to sit closer to
the Pi, or an extra tall one if you want it to sit above the USB/Ethernet
ports.
A bit of light soldering is required to attach the header to the PCB.
This bonnet is designed for use with Raspberry Pi Zero but you can put
on top of any Raspberry Pi with a 2x20 connector, it will just not stick
out as far.
Raspberry Pi Zero not included!
Product Dimensions: 65.1mm x 30.1mm x 1.5mm / 2.6" x 1.2" x 0.1"
Product Weight: 5.3g / 0.2oz