User Manual

forth instantly, try adding a delay of a second after moving to make sure it got to the angle you want!

Although the angles range from 0 to 180, servos may have different ranges depending on the make and model. Also,

each servo is a little different, so you may not get precisely the same angle even if its the same servo!

Tweaking/adjusting the angle may be necessary.

Precise Pulses

For advanced use, you can hand-tune the pulse width. The 'standard' for servos is that 0 degrees is 1000 microseconds

(us), 90 degrees is 1500 and 180 degrees is 2000 us. But...like we said, it can vary. You may want to try values as low

as 750us and as high as 2500us! Just go slow, changing the values only 100us at a time, so you dont thwack the servo

gears too far, they could be damaged if they push too far! For that reason, we recommend using angles only until

you're comfy with servo usage

https://learn.adafruit.com/adafruit-crickit-creative-robotic-interactive-

construction-kit

Page 60 of 201