User Manual

https://adafru.it/CyB

https://adafru.it/CyC

Controlling servos is basically the same through a Crickit as through MakeCode directly.

There's two blocks you can use, one for setting the angle and one for setting the pulse width directly

We recommend using the angle block, its easier! Select which servo you want to use, from 1 through 4

Then adjust the angle. Remember it does take a little time for the servo motor to move, so you can't just set it back and

Are your servos not moving a full 180 degrees? Don't fret! This is normal, see below about putting in custom

pulse lengths to get the 'max range' your servo!



https://learn.adafruit.com/adafruit-crickit-creative-robotic-interactive-

construction-kit

Page 59 of 201