User Manual

also does not connect to the Feather or Circuit Playground USB.

It's

only

for debugging/reloading seesaw firmware. Basically, if we add more Crickit capabilities, you could load new

firmware over this USB connection. In general, you won't be using this port, you may want to cover it with some

masking tape!

To the right is a yellow Activity LED, which will flash when seesaw sends/receives commands from your Circuit

Playground or Feather. To the left is a seesaw NeoPixel. You can control this NeoPixel if you like, to give you status

information, as an advanced usage

The internal NeoPixel is on seesaw pin #27

https://learn.adafruit.com/adafruit-crickit-creative-robotic-interactive-

construction-kit

Page 22 of 201