User Manual

example), or

analog input.

This lets you add a ton of external components easily, and its all handled by seesaw. Perfect when you have a Feather

without analog inputs (like the ESP8266) or just need a ton of extra pins.

The signal pins are on a 3x8 female header, so you can poke wires directly in!

Here's an example wiring that goes with the code below.

We have two switch buttons, connected to signals #1

and #2, the other side of the buttons connect to ground

There's also two LEDs, connected to the signals #3 and

#4 and the negative wires connected to ground. (All the

3.3V and Ground pins are connected together so you

don't

have

to use the ones right next to the signal pin!)

https://learn.adafruit.com/adafruit-crickit-creative-robotic-interactive-

construction-kit

Page 107 of 201