Datasheet

Now open up the Serial console on the receiver, while also checking in on the transmitter's serial console. You should

see the receiver is...well, receiving packets

And, on the transmitter side, it is now printing Got Reply after each transmisssion because it got a reply from the

receiver

Before uploading, check for the #define FREQUENCY RF69_915MHZ line and comment that out (and

uncomment the line above) to match the frequency of the hardware you're using



These examples are optimized for the Feather 32u4/M0. If you're using differnet wiring,

uncomment/comment/edit the sections defining the pins depending on which chipset and wiring you are

using! The pins used will vary depending on your setup!



https://learn.adafruit.com/adafruit-feather-32u4-radio-with-rfm69hcw-

module

Page 58 of 78