Datasheet

Once uploaded you should see the following on the serial console

Now open up another instance of the Arduino IDE - this is so you can see the serial console output from the TX device

while you set up the RX device.

Before uploading, check for the #define FREQUENCY RF69_915MHZ line and comment that out (and

uncomment the line above) to match the frequency of the hardware you're using

These examples are optimized for the Feather 32u4/M0. If you're using differnet wiring,

uncomment/comment/edit the sections defining the pins depending on which chipset and wiring you are

using! The pins used will vary depending on your setup!

https://learn.adafruit.com/adafruit-rfm69hcw-and-rfm96-rfm95-rfm98-lora-packet-padio-

breakouts

Page 29 of 70