Datasheet

Of course, you will also need an antenna of some sort, that matches your radio frequency

Check the bottom of the uFL connector, note that

there's two large side pads (ground) and a little inlet

pad. The other small pad is not used!

Put down a touch of solder on the signal pad

uFL connectors are rated for 30 connection cycles, but be careful when connecting/disconnecting to not rip

the pads off the PCB. Once a uFL/SMA adapter is connected, use strain relief!

https://learn.adafruit.com/adafruit-rfm69hcw-and-rfm96-rfm95-rfm98-lora-packet-padio-

breakouts

Page 19 of 70