User Manual

You can then click the Burn Bootloader menu entry and the Arduino IDE will attempt to use the JLink or STLink (via

AdaLink (https://adafru.it/fPq)) to reflash the bootloader for you.

Compiling your Sketch

At this point you're ready to start flashing your projects to the WICED Feather as you would with any other Arduino

compatible development board!

If you run into any problems, make sure that the WICED Feather BSP is properly configured, that you have installed the

appropriate ARM Cortex M3 toolchain, and that the IDE is setup with the following values:

Board: Adafruit WICED Feather

Section: User Code

Serial Port: Typically the numerically lowest WICED CDC port, but it should be set to the COM port that appears

as 'WICED Feather Serial' in the Device Manager on Windows where the order of enumeration may change.

Then just click the 'Upload' arrow icon, and the compilation and USB DFU flashing process should start, which will

result in the following output: